HONDA FG110 - Manual (Page 20)

18
SERVICING YOUR TILLER
ENGINE
Engine Oil Level Check
Check the engine oil level before each use, or every 10
hours if operated continuously. Rest the tiller on a level
surface, with the engine stopped and in an upright
position.
1. Tip the tiller on its carry handlebar as shown.
2. Remove the oil filler cap/dipstick and wipe it clean.
3. Insert and remove the dipstick without screwing it
into the filler opening. Check the oil level shown
on the dipstick.
4. If the oil level is low, fill to the edge of the oil filler
hole with the recommended oil (see page 19). To
avoid overfilling or underfilling, be sure the engine is
in a level position, as shown.
NOTICE
Running the engine with too little or too much oil can
cause engine damage.
5. Screw in the oil filler cap/dipstick securely.
Engine Oil Change
Drain the used oil while the engine is warm. Warm oil
drains quickly and completely.
1. Place a suitable container below the engine to catch
the used oil.
2. Remove the oil filler cap/dipstick.
3. Tip the tiller to drain the used oil through the oil filler
opening. Allow the used oil to drain completely.
Please dispose of used motor oil in a manner that is
compatible with the environment. We suggest you
take used oil in a sealed container to your local
recycling center or service station for reclamation.
Do not throw it in the trash, pour it on the ground or
down a drain.
4. With the engine resting on the carrying handlebar on
a level surface, fill to the edge of the oil filler hole
with the recommended oil (see page 19). Do not
overfill.
5. Screw in the filler cap/dipstick securely.
OIL FILLER
HOLE
OIL FILLER
CAP/DIPSTICK
CARRYING
HANDLEBAR
OIL LEVEL