HoMedics Adjustable Lumbar massage cushion CUV-200 CUV-200-1 - Manual (Page 3)

Instructions for Use
For Use in Home or Office
Plug adapter into a 120 volt AC outlet and plug the receptacle end into
the input jack, located on the side of the cushion. Attach the massage cushion
to any chair for a luxurious massage as you read, rest or even work.
For Use in Your Car
Simply plug the 12 volt auto adapter into a 12V DC outlet and plug
the receptacle end into the input jack, located along the side of the cushion.
Slip the massage cushion onto your seat to enjoy a relaxing massage
as you drive.
Lumbar Inflation/Adjustment
• To adjust the lumbar support to your comfort level, squeeze the air pump (fig
1) repeatedly until desired support is achieved.
• To deflate lumbar support, press the release valve (fig 1) and apply steady,
gentle pressure to center of cushion until it is completely deflated.
Maintenance
To Store
Place massager in its box or in a safe, dry, cool place. Avoid
contact with sharp edges or pointed objects which might cut or puncture the
fabric surface. To avoid breakage, do not wrap the power cord around the unit.
Do not hang the unit by the controller cord.
To Clean
Unplug the unit and allow it to cool before cleaning. Clean only
with a soft, slightly damp sponge. Never allow water or any other liquids to
come into contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture
polish, paint thinner to clean.
• Do not attempt to repair the massager. There are no user serviceable parts.
For service, send the unit to the HoMedics address listed in the warranty
section.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
4 5
Please Note:
Please allow 5-10
minutes for heat
to reach maximum
temperature.
Caution:
All servicing of
this massager
must be
performed by
authorized
HoMedics
service
personnel only.