Hitachi HV-D25 - Manual (Page 42)

29
<ID/TITLE Setup Procedure>
ΠWith the cursor located at DATA SET, press the D button. The cursor moves to the ID data set position an
the first character flashes.
• Using the L, R, U and D buttons, select an input character.
Ž Press the SET UP button, and the selected character will be entered. (The cursor will then move to the next
character position.)
• In the same manner, repeat the above steps and to enter an ID code and TITLE.
• On completion of character input, bring the cursor to RET using the L, R, U or D button. Then, press the SET
UP button.
The cursor is returned to DATA SET.
‘ To quit the SPECIAL SET mode, press the SET UP button.
← :Flashing shifts one character toward the left.
→ :Flashing shifts one character toward the right.
DEL: Flashing character is deleted, and the subsequent character string is shifted left.
INS : A space is inserted at the flashing character position, and the subsequent character string is shifted
right.
RET : The cursor is returned to DATA SET.
14. DTL
Menu for setting detail parameters
1) LEVEL DEP: Dependent level setting
Detail amount, and noise, can be reduced in scene dark components.
Setting range is -128 to +127. Press the R button to increase the value, reduce the detail amount and expand
the video signal level range. Press L button to decrease the value and reduce the range. Set to 0 by
simultaneously pressing the L and R buttons for about 2 seconds.
2) CRISP: Crispness level setting
Reduces noise when DTL setting is in the range of -128 to 127. However, at high settings, some loss of
sharpness occurs in detailed scene components. Setting range is -128 to +127. Press the R button to increase
the value and the detail noise. Press the L button to decrease the value and reduce detail noise. Set to 0 by
simultaneously pressing the L and R buttons for about 2 seconds.
3) H/V BALANCE: Balance setting for horizontal and vertical detail amount
Setting range is -128 to +127. Press the R button to increase the value and reduce the H DTL amount. Press
the L button to decrease the value and reduce the V DTL amount. Set to 0 by simultaneously pressing the L
and R buttons for about 2 seconds.
4) INITIALIZE: Return each item to factory settings by simultaneously pressing the L and R buttons for about 2
seconds.