Harbor Freight Tools Central Machinery 10" Disc Sander-Bench Type 47404 - Manual (Page 5)

Page 5 SKU 47404 For technical questions, please call 1-800-444-3353.
material faster than it was designed to sand.
12. DO NOT ATTEMPT TO SAND WORKPIECES TOO SMAll TO SAFElY HOlD
BY HAND. Attempting to hold onto a very small workpiece will bring fingers and
hands in dangerous proximity to the spinning sanding disc.
13. WHEN SANDINg A lARgE WORKPIECE, MAKE SuRE IT IS PROPERlY
SuPPORTED AT THE WORK TABlE (part #7) HEIgHT.
14. NEVER lEAVE THE DISC SANDER uNATTENDED WHEN IT IS RuNNINg.
Turn off the machine, and wait until it has completely stopped before leaving.
15. AlWAYS uNPlug THE DISC SANDER FROM ITS ElECTRICAl SuPPlY
SOuRCE BEFORE PERFORMINg ANY INSPECTION, MAINTENANCE, OR
ClEANINg PROCEDuRES.
16. WARNINg: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are: lead from lead-based paints, crystalline silica from bricks
and cement or other masonry products, arsenic and chromium from chemically
treated lumber. Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq.)
18. WARNINg: People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
uNPACKINg
When unpacking, check to make sure all the parts shown on the Parts list on page 11
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.