Healthrider HRTL08011 - Manual (Page 7)

3. With the help of a second person, carefully tip the
Uprights (64) back to the vertical position.
Turn the Handrail Extension (34) so that the two larger
holes are on the bottom. Insert the Handrail Extension as
far as possible into the post on the left Upright (64). If
necessary, tap the Handrail Extension with a rubber mal-
let to fully insert it. Next, attach the Handrail Extension by
tightening two Extension Screws (35) into the indicated
holes.
Identify the Left Foam Grip (31) (see the inset drawing).
Remove the paper from the two indicated pieces of Foam
Tape (82). Apply a small amount of water to the pieces of
Foam Tape. Slide the Left Foam Grip as far as possible
onto the post on the left Upright (64). It may be helpful
to lubricate the Handrail Extension (34) with soapy
water. Press two Plastic Fasteners (9) into the Foam Grip
and the Handrail Extension (34). If necessary, use a blunt
object to press in the Plastic Fasteners.
4. Attach the other Handrail Extension (34) and the Right
Foam Grip (43) as described above. Make sure to attach
three Extension Screws (35) as shown.
5
5. Position the Latch Spacer (106) and the Latch Assembly
(32) as shown. Attach the Latch Spacer and the Latch
Assembly to the Left Foam Grip (31) with the long Latch
Screws (105) as shown. Note: Tighten the two Latch
Screws as tight as possible.
32
31
105
106
64
31
64
9
35
Post
34
3
6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place; the allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
31
43
82
Holes
43
64
9
35
Post
34
82
Holes
4
7
105