Operation, Before starting engine – Husqvarna 7021RC User Manual

Page 8

Advertising
background image

8

OPERATION

BEFORE STARTING ENGINE

ADD OIL (See Fig. 12)

Your lawnmower is shipped without oil in the engine. For type
and grade of oil to use, see “EN GINE” in the Maintenance
section of this manual.

CAUTION: DO NOT overfi ll engine with
oil, or it will smoke heavily from the muf-
fl er on startup.

1. Be sure lawnmower is level.

2. Remove oil fi ll cap / dipstick from oil fi ll spout.

3. Engine holds 18.5 ounces of oil. Pour oil slowly. Do

not overfi ll. Wait one minute to allow oil to settle. Use
gauge on oil fi ll cap/dipstick for checking level. Insert
dipstick into the tube and rest the oil fi ll cap on the
tube. DO NOT thread the cap into the tube when tak-
ing reading.

4. Insert and tighten oil fi ll cap / dipstick.

IMPORTANT:

Check oil level before each use. Add oil if needed. Fill
to full line on dipstick.

Change the oil after every 25 hours of operation or each
season. You may need to change the oil more often
under dusty, dirty conditions. See “TO CHANGE EN-
GINE OIL” in the Maintenance section of this manual.

GASOLINE

FILLER CAP

OIL FILL CAP/
DIPSTICK

LOWER
MARK

UPPER
MARK

FIG. 12

SIMPLE STEPS TO REMEMBER

WHEN CONVERTING YOUR LAWN MOWER

FOR MULCHING -
1. Rear mulcher plug installed.
2. Mulcher door closed.
FOR REAR BAGGING -
1. Rear mulcher plug removed.
2. Grass catcher installed.
3. Mulcher door closed.
FOR SIDE DISCHARGING -
1. Rear mulcher plug installed.
2. Discharge defl ector installed.

CAUTION: Do not run your lawn mower
without mulcher plug or ap proved grass
catch er in place. Nev er at tempt to op er-
ate the lawn mow er with the rear door
re moved or propped open.

TO EMPTY GRASS CATCHER
(See Figs. 10 and 11)

FIG. 11

FRONT

HANDLE

REAR

HANDLE

STRAP

FIG. 10

ROUND DOOR

STARTER ROPE

OPEN

FRONT HANDLE

1. Open round door of discharge chute to move starter

rope out and away from grass catcher.

2. Remove grass catcher with clippings from lawn mower

using both front and rear handles.

3. Empty clippings from grass catcher using both rear

handle and strap. The weight of the grass will open
the door.

4. Snap door shut over frame before installing grass

catcher on mower.

NOTE: Do not drag the bag when emptying; it will cause
unnecessary wear.

Advertising
This manual is related to the following products: