Harbor Freight Tools 97028 - Manual (Page 8)

Page 8 SKU 97028 For technical questions, please call 1-800-444-3353.
read the ENTirE imPOrTaNT saFETY iNFOrmaTiON section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Figure 3
air Outlet, connect
hose to Hammer
air inlet, connect hose
to air compressor
The Frame (24) should be positioned so that the mounted Mini Planishing Ham- 7.
mer is extending slightly over the edge of the workbench. This will help to accom-
modate various shapes being plannished.
Screw off the Coil Spring (15) and remove the Anvil Head (21) and Hammer
8.
Shank (23) from the Cylinder (14).
Slide the Hammer Body (1) into the Frame (24).
9.
Insert the Anvil Head (21) into the Anvil Shaft (19) and tighten in place with Hex 10.
Screw (20).
Place the Anvil Head (21) and Hammer Shank (23) into the Coil Spring (15) and
11.
screw onto the Cylinder (14). see Parts list and assembly diagram on page
11 and 12.
OPEraTiNg iNsTruCTiONs
REV 08a