Hitachi 61UWX10B - Manual (Page 12)

REAR PANEL JACKS
12
ቧ
Component: Y-P
B
P
R
Inputs
Inputs 4 and 5 provide Y-P
B
P
R
jacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may
use standard video signal for INPUT:4 and 5.
Items
ቨ
~
ቫ
are for 53/61SWX10B and 53/61SWX12B only.
ቨ
REAR SPEAKER Output Terminals
These terminals are used to connect external speakers, which are used for the surround sound feature. The volume level is
controlled by the televisionÕs main volume. These speaker output terminals can be turned on and off in the THEATER-SPEAKER
SETUP menu. Use speakers with 8-Ohm impedance only.
ቩ
Optical Input
This jack provides high quality audio input from a Dolby Digital DVD player or HDTV Set Top Box. Use a digital optical cable to
connect your TV to a compatible device. This input can be used for VIDEO: 4 or VIDEO: 5 audio, as selected in the THEATER-
INPUT SOURCE menu. (see page 68)
ቪ
Coaxial Input
This jack provides high quality audio input from a Dolby Digital DVD player or HDTV Set Top Box. This input can be used for
VIDEO: 4 or VIDEO: 5 audio, as selected in the THEATER-INPUT SOURCE menu. (see page 68)
ቫ
SUB WOOFER Output
This jack provides variable audio output to a sub-woofer accessory. With this connection, the audio can be controlled by the
televisionÕs main volume. This feature can be turned on and off in the THEATER-SPEAKER SETUP menu.
NOTES: 1. DO NOT connect standard VIDEO and S-VIDEO to Input 1, 2 or 3 at the same time. S-Video has a higher priority over video input.
2. When using the Y-PBPR input jacks, connect your components audio output to the TVÕs Input 4 or 5 Left and Right Audio input jacks.
If your component has a Coaxial Out or Optical Out, use these connectors in place of the standard Audio L/R output jacks.
3. Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TVÕs PB input and
the components R-Y output to the TVÕs PR input.
4. Your component outputs may be labeled Y-CBCR. In this case, connect the component CB output to the TVÕs PB input and the
component CR output to the TVÕs PR input.
5. It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPR inputs. (See page 56)
6. To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPR jacks.
7. This TVÕs optical digital input jack fully complies with the international standard governing this type of jack (IEC958), and is designed
for connection to a Dolby Digital (AC-3 or PCM) DVD Player or Dolby Digital (AC-3 or PCM) HDTV Set Top Box. Older equipment,
some of which is not fully compliant with IEC958, may not be compatible with the Dolby Digital bitstream. Such a connection using
anything other than Dolby Digital AC-3 or PCM bitstream could create a high noise level, causing damage to your speakers.