Place the library in the rack, Place the library in the rack -17, Figure 1-11. strain relief bracket -17 – HP SureStore 4215w User Manual
Page 31
1-17
Installing the Tape Library
Step 4: Mount the Library in a Rack (optional)
In
st
a
lla
tio
n
Place the Library in the Rack
1. Attach the cable strain relief bracket to the library rear panel below the SCSI
connectors using one 6-32 x 3/8 pan phlp, with internal lockwasher screw.
Figure 1-11
Strain Relief Bracket
2. Ensure that the rack’s anti-tip rails are extended.
WARNING
Failure to extend the rack’s anti-tip rail could result in personal injury and/or
damage to the tape library.
3. Remove the keys from the library handle.
4. Important – two people needed: Lift the library onto the slides and back slightly
into the rack using the side handles. Make sure the handles sit securely on the
slides and that the front holes in the library line up with the second hole from the
front on the slides.
WARNING
Do not attempt to move the tape library by yourself.
The tape library weighs approximately 100 pounds (45 kilograms). To avoid
personal injury and/or damage to the tape library, a minimum of two people
are needed to move the library.