Hunter Fan Type T Models - Manual (Page 6)

6
42747-01 • 09/21/07 • Hunter Fan Company
3 • Assembling and Hanging the Fan
You can assemble your fan for standard mounting (steps 3-1 – 3-2)
or for low profile mounting (steps 3-3 – 3-4). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
3-2. Loosen the allen head set screw on the adapter using the large
allen wrench. Screw the pipe and ball assembly into the fan
assembly. Note: When the pipe and ball assembly is fully installed,
2-3 threads on the pipe will still be visible; this is normal. Securely
retighten the set screw with a wrench or pliers. Skip to Step 3-5.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-3. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
3-4. Align the holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 3/4” screws.
3-5. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-3 – 3-4
#8-32 x 3/4” Screw
Low Profile Washer
Steps 3-1 – 3-2
Downrod
Canopy
Canopy
Trim Ring
Set Screw
Step 3-5
U-shaped
Hole