HONDA Automobile Accessories - Manual (Page 2)

2 of 10 AII 21619 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should
not be attempted by "do-it-yourselfers."
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Inside the passenger compartment, remove the
front console lower cover (four retaining clips).
RIGHT
FUSE BOX
CONTROL UNIT
LEFT
FUSE
BOX
6-PIN RELAY
4-PIN
RELAY
Keyless Entry System (sold separately):
P/N 08E61-S84-100
Control unit
Owner’s Manual
2 Washer-screws, 4 x 30 mm
TOOLS AND SUPPLIES REQUIRED
Small flat-tip screwdriver
#2 Phillips screwdriver
Tape measure
File
Felt-tip pen
Pliers
17 mm Combination wrench
10 mm Socket wrench
Ratchet
Utility knife
KEYLESS
ENTRY WIRE
HARNESS
FRONT
CONSOLE
LOWER COVER
CLIP
Illustration of the Keyless Entry Installed on the
Vehicle
2 Transmitters