Heath Zenith SL-4190 - Manual (Page 5)

5 595-5628-07
TESTING
❒ Turn on the circuit breaker and light
switch.
The detector is less sensitive to motion
directly towards it and more sensitive to
across motion.
Sensor
Motion
Least Sensitive Most Sensitive
❒ Walk through the coverage area noting
where you are when the lights turn on.
❒ If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
❒ Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
❒ Set the amount of time after dusk you want
the lights on accent level.
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 30 ft. (9.1
m ) [ va r i e s w i t h
s u r r o u n d i n g
temperature].
Sensing Angle . . . . . . Up to 180°
Electrical Load . . . . . . S e e r a t i n g o n
fixture for maximum
wattage.
Sensor Capacity . . . . Up to 360 Watt (3.0
A.) Maximum
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and
MANUAL MODE
Time Delay . . . . . . . . 1, 5, 10 minutes
D
UAL
B
RITE
® timer . . . . 3, 6 hrs, Dusk-to-
Dawn
DESA Specialty Products™ reserves the
right to discontinue products and to change
specifications at any time without incurring
any obligation to incorporate new features in
products previously sold.
NOTE: Sensor has a 1 1 /
2
minute warm up pe-
riod before it will detect motion. When
first turned on, wait 1
1 /
2
minutes.
TEST 1 5 10 MIN
ON-TIME
OFF 3 6 DUSK TO
HOUR DAWN
Avoid aiming the control at:
• Objects that change temperature rapidly,
such as heating vents and air condition-
ers. These heat sources could cause false
triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects
reflecting light may trigger the shut-off
feature. Do not point other lights at the
sensor.
30 ft.
(9.1 m)
Maximum Range Maximum
Coverage Angle
6 ft.
(1.8 m)
180°
Motion
❒ Switch the on-time to TEST position and
D
UAL
B
RITE
® switch to the OFF position.