Hearth and Home Technologies B-Vent Gas Appliance CB4842MIR - Manual (Page 31)

Heatilator • Caliber Mesh BV Series • 4040-848 Rev G • 10/08 31
Latches
(both bottom
and top)
Glass
Assembly
Figure 14.8 Fixed Glass Assembly
H. Install the Log Assembly
• Base logs have been permanently mounted on the grate
assembly and should not be moved. See Figure 14.5.
Figure 14.7 Placing Right Top Log
Figure 14.6 Placing Left Top Log
Figure 14.5 Base Logs
• Install “Y” log on left hand side of grate using locating
pins to position. See Figure 14.6.
• Install right top log as shown in Figure 14.7 using locating
pins to position log properly.
I. Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Glass Assembly
• Remove mesh fi rescreen (refer to Figure 14.15).
• Lift and pull the upper latch cover towards you to expose
the two (36 in. model) or three (42 in. model) glass
latches.
• Lift and pull lower latch cover to expose the two (36 in.
model) or three (42 in. model) glass latches.
• Rotate the bottom of the screen assembly away from
the appliance and lower out of the top retainers.
• Release the top and bottom access latches and rotate
the top of the glass assembly away from the top of the
appliance.
• Place the glass assembly on a surface that will not
scratch the surface of the glass assembly.
Replacing Glass Assembly
• Replace the glass assembly on the lower access
latches.
• Rotate the upper portion of the glass assembly into
place.
• Engage the top access latches.
• Engage the lower access latches.
• Reinstall upper latch cover (see Figure 14.12).
• Reinstall lower latch cover (see Figure 14.14).
• Reinstall
mesh fi rescreen (see Figure 14.15).