Havis-Shields Telescoping Computer Base C-TCB-21 - Manual

C-TCB-21-INST-12-04
INSTALL INSTRUCTIONS C-TCB-21
TELESCOPING COMPUTER BASE
1998-2003 DODGE DURANGO
TOOLS REQUIRED:
3/16” Allen wrench
3/8” Standard socket set
3/8” Metric socket set Ratcheting wrench (3/8” drive)
Powered drill w/ 3/16” drill bit
Open-end wrench set
HARDWARE & COMPONENTS:
QTY DESCRIPTION PART
#
1 Pole support assembly CM93071-21
1 Telescoping pole assembly CM93072-3
1 Side support brace CM93146
1 5/16-18 Nylock nut GSM30017
1 5/16” Flat washer GSM31006
2 ¼” x 1” Hex head lag bolts GSM33060
Always !
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
¼” x 1”Hex
head lag bolts
5/16-18
Nylock nut
Side support
brace
Telescoping pole
assembly
Pole support
assembly
Location of
passenger side factory
seat base bolts