Product features, Assembly and operating instructions – Harbor Freight Tools 91033 User Manual
Page 6
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram (page 8).
NOTE: Always check the hose for cracking or other damage. Never use a damaged
hose.
1.
Prior to use, the Hose (21) must be attached to the Propane Torch. To do so,
wrap about 3” of pipe thread tape (not included) around the male threads of the
Hose Connector (12). Then, use the accessory 19MM Open End Wrench to
firmly tighten the Handle Connector (23) onto the Hose Connector.
(See Figure A.) Note: This is a left hand thread.
2.
Make sure the Hand Wheel (6) is turned completely
clockwise
to the “OFF”
position. (See Figure A.)
3.
Screw the Cylinder Connector (24) firmly into the female hose connector of the
L.P. tank. NOTE: The fitting is a reverse thread - 20 Lb. LPT.
4.
The Hand Wheel (6) regulates the propane gas flow. Release the propane gas
flow by slightly turning the Hand Wheel
counterclockwise
. (See Figure A.)
5.
Make sure the Burner (1) is pointing in a safe direction. Insert the lit end of a
commercial, long handled, fireplace/barbecue grill
lighter
through one of the slots
located on the Burner. (See Figure A.)
PRODUCT FEATURES
1.
The Propane Torch is ideal for de-icing, removing paint (only from non-flammable
surfaces), removing weeds (only in a controlled, safe environment, and softening as-
phalt for removal or patching. In addition, the Propane Torch easily attaches to standard
20 Lbs., Barbeque L.P. (propane) tanks (not included).
SKU 91033
PAGE 6
BURNER (1)
HAND WHEEL
(6)
CYLINDER CONNECTOR
(24)
HOSE
(21)
HOSE CONNECTOR (12)
HANDLE CONNECTOR (23)
LEVER
(19)
19MM OPEN END WRENCH
17MM OPEN END WRENCH
FIGURE A
HANDLE (11)
ASSEMBLY AND OPERATING INSTRUCTIONS