Hoshizaki REFRIGERATED GLASS MERCHANDISER KD-90D - Manual (Page 6)

4
* Allow at least 6” (15 cm) clearance around the merchandiser for proper air circulation
and ease of maintenance and/or service should they be required.
2) Level the merchandiser in both the left-to-right and front-to-rear directions. Metal shims
should be added under the feet to level the system.
3. ELECTRICAL CONNECTIONS
WARNING
This refrigerated merchandiser requires a ground that meets the national and
local electrical code requirements. To prevent possible severe electrical shock
to individuals or extensive damage to the equipment, install a proper grounding
wire to the merchandiser.
* This merchandiser must be plugged into the separated power receptacle which has enough
capacity. The maximum allowable voltage variation should not exceed ± 10 percent of the
nameplate rating. See the Nameplate.
* Usually an electrical permit and services of a licensed electrician are required.
Note: This merchandiser is equipped with a Ground Fault Circuit Interrupter (GFCI). Locate
the GFCI on the upper middle part of the rear, next to the Rocker Switch for Fluorescent
Lamp.
4. DRAIN CONNECTIONS
No plumbing is required as a slide-out
Cassette Tank is provided. Attach the
Cassette Tank to the bottom of the
merchandiser.
Drain Hose
Bracket
Drain Hole
Rear
Front
Tank Drain Hole
Cassette Tank
(Capacity: approx. 0.4 gal)