Technical specifications, Conformity certificates – Husqvarna 450 User Manual
Page 14
14
TECHNICAL SPECIFICATIONS
Weight and Dimensions 450
Weight – dry
132 lbs
60 kg
Weight with gasoline and oil full
139 lbs
63 kg
Length
34 inch
864 mm
Width
19 inch
483 mm
Height
21 inch
533 mm
Blade
Material cut
Green concrete only
Blade type
8.0” (203 mm) dry cut with tri-arbor
Blade rotation
Counter clockwise, upcutting
Blade shaft speed
3350 rpm
Cutting depth
1 to 1 3/16 inch (25 to 30 mm) depending on amount of
blade wear
Cutting distance from wall
3 inch
76 mm
Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.
Soft aggregates
13 ft/min
4.0 m/min
Medium aggregates
9 ft/min
2.7 m/min
Hard aggregates
5 ft/min
1.5 m/min
Engine:
Robin EX17
Engine oil volume
0.6 quart
0.6 liter
Gasoline tank volume
1.0 gal
3.6 liter
Type
Air cooled, 4-cycle, single slant cylinder, overhead
camshaft, gasoline engine
Air filter
Cyclonic type
Oil system
Oil alert with auto shut down sensor
Muffler
Silent type 77 dbA, exhaust deflector, spark arrestor
Emissions
Complies with EPA Phase 2 and CARB Tier II USA
regulations
Cooling
Air cooled with internal and external cooling fins
Cylinder
Aluminum with cast iron liner
Controls
Engine mounted manual throttle, choke and fuel shut
off levers, manual on/off switch
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Saws :
concrete, masonry, cutoff, with engine power less than
1
9KW (
25
hp), CARB standards do not apply to this
machine.
For more information see the website
http://www.arb.ca.gov/msprog/offroad/preempt.htm
CONFORMITY CERTIFICATES