HP 2610-PWR - Manual (Page 165)

N o t e o n M S T P
R a p i d S t a t e
Tr a n s i t i o n s
N o t e
Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
Under some circumstances the rapid state transitions employed by MSTP (and
RSTP) can increase the rates of frame duplication and misordering in the
switched LAN. To allow MSTP switches to support applications and protocols
that may be sensitive to frame duplication and misordering, setting the Force
Protocol Version (
force-version) parameter to stp-compatible allows MSTP to
operate with rapid transitions disabled. The value of this parameter applies to
all ports on the switch. See the information on
force-version on page 62.
Steps for Configuring MSTP
This section outlines the general steps for configuring MSTP operation in your
network, and assumes you have already planned and configured the VLANs
you want MSTP to use. The actual MSTP parameter descriptions are in the
following sections.
The switch supports MSTP configuration through the CLI. After you specify
MSTP and reboot the switch as described above, the switch removes the
Spanning Tree option from the Menu interface. If you later reconfigure the
switch to use STP or RSTP, the switch returns the
Spanning Tree option to the
Menu interface.
This section assumes that you have already
1. Configured the MSTP operation mode. This specifies MSTP as the span­
ning tree operating mode. Changing the current MSTP operation mode
requires you to save the change and reboot to activate the selection.
spanning-tree protocol-version < stp | rstp | mstp >
2. Configure MSTP global parameters. This step involves configuring the
following:
• Required parameters for MST region identity:
Region Name: spanning-tree config-name
Region Revision Number: spanning-tree config revision
• Optional MSTP parameter changes for region settings:
ProCurve recommends that you leave these parameters at their
default settings for most networks. Refer to the “Caution” on page 49.
– The maximum number of hops before the MSTP BPDU is dis­
carded (default: 20)
spanning-tree max-hops
5-57