HP 2610-PWR - Manual (Page 250)

Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Classifiers To Configure QoS for Outbound Traffic
Quickly Listing Non-Default Codepoint Settings
Table 6-11 lists the switch’s default codepoint/priority settings. If you change
the priority of any codepoint setting to a non-default value and then execute
write memory, the switch will list the non-default setting in the show config
display. For example, in the default configuration, the following codepoint
settings are true:
Codepoint Default
Priority
001100 1
001101 No-override
001110 2
If you change all three settings to a priority of 3, and then execute write memory ,
the switch will reflect these changes in the show config listing.
Configure these three codepoints
with non-default priorities.
Show config lists the non default
codepoint settings.
Figure 6-33. Example of Show Config Listing with Non-Default Priority Settings in
the DSCP Table
6-60