Installation – Heath Zenith SL-6107 User Manual

Page 7

Advertising
background image

-7-

595-4514-13

❐

Mount the SL-6107 into the junction box with the two junction box
screws.

❐

Turn the circuit breaker back on.

❐

Preset the controls: Time to min. (fully counter-clockwise), Photo
Adjustment fully clockwise. Cover the lens with masking tape.

❐

With the motion sensor in the “ON” position, turn the remote
switch on and off several times. Go to step 1, 2, or 3, depending
on results.

INSTALLATION

* Turn power off before rewiring!

Test again. Go

to 2 or 3.

If light does

not turn on:

1.

Exchange*

Control's

Red

⇔

Black

wires.

➯

If light turns on

with remote

switch in either

position:

3.

Set sensor to “AUTO”. Wait for the

unit to warm up (up to 1 min.). If

the remote switch can turn the

lights on, it's OK.

Otherwise:

Exchange* Control's

Black

⇔

Brown wires. Remove

the tape. Go to the next page.

2.

➯

If light turns on in

only one position

of remote switch:

Exchange*

Control's

Red

⇔

Brown

wires.

Troubleshooting Wiring Connections

➯

Test again. Go

to 1 or 3.

➯

➯

➯

Advertising