Husqvarna HUV 4213-GXP - Manual (Page 39)

Battery
2. Access the engine compartment. See WARNING “For vehicles with cargo beds...” in General Warnings
on page 9.
3. Tilt the bed and ensure that the prop rod is properly engaged.
4. Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally starting...” in
General Warnings on page 9.
5. Use a flat blade screwdriver, and carefully remove the battery cell caps from the battery (Figure 25). See
following WARNING.
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
6. Carefully check the electrolyte level and add distilled water if necessary. Do not fill above designated fill line.
Replace battery cell caps.
7. Clean both battery terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per gallon (3.8
L) of water). Rinse thoroughly. Do not allow this solution to enter the battery. Tighten battery terminals to 144
in-lb (16 N·m). Let the terminals dry and then spray them with Battery Terminal Protector Spray (P/N 603 00
00-03). See following CAUTION.
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to
do so may cause them to overheat during operation and could result in fire, property damage, or
personal injury.
1
3
2
1. Level Indicator 2. Cap 3. Plates
Electrolyte level at least 1/2 inch (13 MM) above plates or to level
indicator.
180
Figure 25 Battery
22
Figure 26 Battery Electrolyte Level
Be sure battery hold-down clamp is properly tightened. Tighten to 144 in-Ib (16 N·m). A loose clamp may allow the
battery to become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged any
longer than absolutely necessary (do not leave discharged overnight).
2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 37