Husqvarna HUV 4213-GXP - Manual (Page 13)

Controls and Indicators
SERIAL NUMBER
HH0601-583947
7349 ST ATESVILLE RD.
CHARLOTTE, NC 28269
47
Figure 3 Serial Number
CONTROLS AND INDICATORS
See General Warnings on page 9.
WARNING
• Before allowing anyone to drive the vehicle, make sure the driver is familiar with all controls and
operating procedures.
• Do not tamper with the governor. Doing so will void the warranty, as well as damage the engine and
other components, and could result in property damage, personal injury, or death due to unsafe
speeds.
• Do not shift the Forward/Reverse handle while the vehicle is in motion.
• Engine must be at idle before shifting the Forward/Reverse handle. Failure to do so may result in
injury to inattentive passengers and (or) damage to the vehicle.
• To avoid injury to an inattentive passenger or damage to the vehicle, always bring the vehicle to a full
stop before shifting the Forward/Reverse handle.
• To avoid unintentionally starting or rolling the vehicle, set the park brake, place the Forward/Reverse
handle in the NEUTRAL position, turn the key switch to the OFF position, and remove the key when
leaving the vehicle.
• With the differential lock engaged, vehicle turning functions are greatly reduced. To prevent loss of
vehicle control when differential lock is engaged, do not operate vehicle at speeds greater than half
throttle and use caution when attempting to turn the vehicle.
2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 11