Husqvarna HUV 4213-GXP - Manual (Page 29)

Periodic Service Schedule
WARNING
• To help avoid unintentionally starting the vehicle:
– Disconnect battery cables, negative (–) cable first (Figure 2).
– Disconnect the spark plug wire from the spark plug.
• If wires are removed or replaced make sure wiring and wire harness are properly routed and secured.
Failure to properly route and secure wiring could result in vehicle malfunction, property damage,
personal injury, or death.
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor
jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised
position. Use approved jack stands of proper weight capacity to support the vehicle and chock
the wheels that remain on the floor. When not performing a test or service procedure that requires
movement of the wheels, lock the brakes.
PERIODIC SERVICE SCHEDULE
See General Warnings on page 9.
WARNING
• Service, repairs, and adjustments must be made per instructions in the appropriate maintenance
and service manual.
• If any problems are found during scheduled inspection or service, do not operate vehicle until repairs
are made. Failure to make necessary repairs could result in fire, property damage, severe personal
injury, or death.
NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, these preventive
maintenance procedures should be performed more often than recommended in the Periodic Service and
Lubrication Schedules.
Both the Periodic Service Schedule and the Periodic Lubrication Schedule must be followed to keep vehicle in
optimum operating condition.
2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 27