Husqvarna FOREST AND GARDEN HUV4210-G - Manual (Page 32)

Storage – Gasoline Vehicles
Page 30 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
4. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of
baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat-
teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry
and then coat them with Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
5. To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the
engine through the spark plug hole. Rotate engine crankshaft by hand several times, then install the
spark plug and tighten to 20 ft-lb (27 N·m).
6. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 50.
7. Perform semiannual periodic lubrication. See Periodic Lubrication Schedules on page 35.
8. Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle.
9. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
Figure 16 Fuel Shut-off Valve – Closed (OFF) Position
Viewed From Selector Side of Valve
1. Closed (OFF) Position
Selector Is Aligned with OFF Markings On the Sides of Valve
Figure 17 Fuel Shut-off Valve – Open (ON) Position Figure 18 Fuel Shut-off Valve –
Partially Closed Position
Viewed From Selector Side of Valve
Full Open (ON) Position Viewed From Selector Side of Valve
Partially Closed Position
1 1