Husqvarna SMC 50 E - Manual (Page 12)

12
– English
DESCRIPTION
Motors
Chain saw engine (FIG. 9)
The one-man sawmill is powered by a standard chain
saw ranging from 65 cm
3 up to 95 cm 3 . The chain saw
is mounted on a vibration-free plate (9), where it is
screwed into the bar mounting with two spacers and
screws (15). The saw’s speed is controlled from the
throttle (17) on the handlebar (18), which is connected
by a cable to the chain saw. The cable is secured in a
special mounting that is screwed onto the saw. For a
further description of the chain saw, see the enclosed
operator’s manual for the chain saw.
FIG. 9
FIG. 10
FIG. 11
9
18
17
24
35
Electric motor feed unit (FIG. 11)
The feed unit is powered by a 42 volt DC motor (35).
The speed of the motor is controlled variably from the
control box.
Electric Motor (FIG. 10)
The one-man saw is powered by a 3-phase motor (21).
The motor is started and stopped with the start and
safety switches on the distribution box, which has built-
in motor protection. There is also a connection for an
electric cable with single phase inversion.