Henkel K-NP User Manual

Page 6

Advertising
background image


THERMOSTAT CALIBRATION

1. Turn on unit. Set control dial at desired temperature.
2. Allow control to cycle at least three times (3) and observe temperature at the middle of the fourth

cycle.

3. If calibration is required, carefully remove dial knob. Do not turn shaft.
4. Turn calibration screw in center of dial shaft clockwise to lower temperature and counter-clockwise

to increase temperature.

5. Allow unit to cycle three (3) times and observe temperature at middle of fourth cycle. Readjust

calibration screw if necessary. Replace dial knob.



RECOMMENDED SPARE PARTS

When it is critical to have continuous operation of this unit, we suggest having the following

spare parts on hand:

1. Heating Element
2. Thermostat
3. Power Cord







K-NP Wiring Diagram 120V / 500W






Thermostat

# 301037

Oven Ground

Temperature

Sensor

Heating Element
#301022

Neon Pilot #301085







-

6

-

Advertising