Hoover S2200 - Manual (Page 7)

Select proper tool
H. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
I. Furniture nozzle may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
J. Powered hand tool may be used for
upholstered furniture, carpeted stairs
and hard-to-reach places.
K. Crevice wand can be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs, and baseboards.
It can also be used for extra reach with
the dusting brush and/or extension
wand.
L. Wands are used to give extra length
to your hose. Use them with any of the
above tools.
7
2-16
J
F
M
A
B
C
D
E
N
K
L
I
H
How to attach tool
cover
The tool cover is designed with a
“break-away” feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
How to clean tools
To clean the hose and the powered
hand tool, wipe off dirt with a cloth
dampened in a mild detergent. Rinse
with a damp cloth. Do not submerge
powered hand tool in water.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air
dry before using.
2-18
2-19
3-1
2-17
3-2
3. Maintenance
Familiarize yourself with these home
maintenance tasks as proper use and
care of your cleaner will ensure contin-
ued cleaning effectiveness.
Dirt cup
The dirt cup assembly consists of the
following parts:
Lid (A)
Dirt Cup (B)
Pre-filter (C)
HEPA Cartridge Filter(D)
Dirt Inlet Opening (E)
While the cleaner is in operation, the pre-
filter screen will stop larger debris from
entering the HEPA cartridge filter chamber.
This larger debris will be seen collecting in
the left side of the dirt cup. The HEPA car-
tridge filter will collect fine particles that
have passed through the pre-filter screen.
When to empty
It is recommended that the dirt cup be
emptied before the dirt reaches the dirt
inlet opening on back of dirt cup (Fig. 3-1)
or after every use if preferred.
CAUTION: Very fine materials, such
as face powder, cornstarch or fire-
place soot, may seal the filter and
cause loss of suction. When using
the cleaner for this type of dust,
empty the cup and clean the filters
often.
How to empty
Disconnect cleaner from electrical
outlet. Do not use cleaner without dirt
cup or filters in place.
Slide latch (F) to the left to unlock.
Lift cup slightly and pull straight out to
remove from cleaner.
Extra hose
(available at additional cost if not includ-
ed with your cleaner)
The extra reach hose provides a 20 foot
reach to allow easier cleaning of stairs
and hard-to-reach high places. To attach
hose to your vacuum cleaner, follow the
instructions below.
Turn cleaner OFF before disconnect-
ing and connecting hose.
Align end of extra reach hose with pro-
jections (M) over slots (N) on end of
attached hose.
Slide hose into slots and twist hose to
lock it into place. (To detach hose,
reverse procedure.)
Attach wands or tools to the other end of
hose.
Continued ➜