Harbor Freight Tools 47613 User Manual
Page 10
UNPACKING
When unpacking, check to make sure all the parts shown in Figure C are included. If any
parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on the last page page of this manual.
CAUTION: Always make sure the Power Cord Circular saw is unplugged from its
electrical outlet prior to making any adjustments to the tool.
Adjusting The Saw Prior to Cutting
1.
Screw the Side Handle (401) into the Circular Saw housing.
2.
To adjust the
angle of blade from 0 to 45 degrees, loosen Wing Nut (60) and
move Base Assy. (52) down, observing the degrees indicated on the angle plate.
Tighten Wing Nut (60).
See Figures D and E on the next page.
3.
To adjust the
depth of the cut, loosen Lock Handle (55) and move Base Assy. (52)
down (or up) while observing the amount of saw blade exposed under base plate.
Tighten Lock Handle (55).
Rip Guide
Side Handle
Saw Blade
Removal Wrench
Saw Blade
Figure C
SKU 47613
Page 10