Hitachi DV-RX5000U - Manual (Page 53)

53
Re
fe
re
nce
Sound Page
Play
Displays
Remote control
No sound.
Low volume.
Distorted sound. ≥Check the connections. Check the input mode on the amplifier if you have connected one.
≥Turn V.S.S. off if it causes distortion.
5,
41–43
37
Cannot hear the desired
audio type. ≥Press [AUDIO] to select the desired audio type. 23
Cannot switch audio during
stereo or SAP broadcasts. ≥You have used digital connection. Set “Dolby Digital” to “PCM” or connect to other equipment
using audio cables (analog connection).
≥You cannot change the audio type when a DVD-R is in the disc tray.
42, 47
—
Play fails to start even when
[
1] (PLAY) is pressed.
Play starts but then stops
immediately.
≥Insert the disc correctly with the label facing up.
≥This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and
MP3 discs.
≥The disc is dirty. Clean it.
≥The disc may be badly scratched.
≥You inserted a blank DVD-RAM or DVD-R.
≥Condensation has formed: Wait 1 to 2 hours for it to evaporate.
15
11
50
—
—
—
A title or chapter doesn’t play
when it is selected. ≥Some titles and chapters on DVD-Video are not played when you have changed the ratings
level.
46
Picture distorted during
search. ≥Some distortion is normal. —
Alternative soundtrack and
subtitles cannot be selected. ≥The languages are not recorded on the disc.
≥You may have to use the disc’s menus to select languages. —
17
No subtitles. ≥Subtitles are not recorded on the disc.
≥Turn the subtitles on. —
36
Angle cannot be changed. ≥This function depends on software availability. Angles can only be changed during scenes
where different angles are recorded.
—
You have forgotten your rat-
ings password. ≥Return the ratings setting to “8”.
While the disc tray is open, press and hold [ :/6] and [5/9] on the main unit at the
same time for 5 or more seconds.
—
The display is dim. ≥Go to the Display menu and change the display’s brightness with “FL Display”. 47
“12:00” is flashing on the
unit’s display. ≥The clock is not set. 49
The displayed recording time
and actual recording time dif-
fer. ≥Displayed recording time is based on the number of frames per second. This number is sub-
ject to minute variations. When recording over long periods, these variations may result in the
difference between displayed recording time and actual recording time. This is normal.
—
The display doesn’t show the
correct time.
[MP3]
≥Times may not appear correctly when searching through tracks recorded with a variable bit
rate.
—
The remote control doesn’t
work. ≥[DVD, TV] is not switched to “DVD”. Switch to “DVD” when operating this unit.
≥The remote control and main unit are using different codes. Change the code on the remote
control or main unit.
≥The batteries are depleted. Replace them with new ones.
≥Point the remote control at the remote control sensor on the main unit.
≥Remove obstacles from between the remote control and main unit.
12
45
6
6
—
Cannot operate the televi-
sion. ≥Change manufacturer code. Some televisions cannot be operated even if you change the
code.
≥[DVD, TV] is not switched to “TV”. Switch to “TV” when selecting the receiving channel for the
television.
10
12