HP Quality Center Synchronizer 1.2 - Manual (Page 102)

Chapter 4 • Working with Quality Center Synchronizer
102
Enabling and Disabling Synchronization Links
Each synchronization link can be in one of the following states:
Unvalidated, Disabled, and Enabled. The following table lists these states
and their descriptions. It also lists under what circumstances the link moves
between states.
To enable a synchronization link:
1 In the Links list or Links Grid, select the link you want to enable.
2 Make sure that the link is in the state Disabled. If the link is in the state
Unvalidated, you must run an integrity check to change its state to
Disabled. For more information on running integrity checks, see “Running
Link Tasks Manually” on page 91.
3 Click the Enable Link button or choose Link > Enable.
State Description When State Entered When State Left
Unvalidated The link’s
configuration
has not been
verified. You
cannot run tasks
for the link. Upon creation of a
new link or
modification of the
configuration of an
existing link. Upon execution of an
integrity check. For
more information on
running integrity
checks, see “Running
Link Tasks Manually”
on page 91.
Disabled The link’s
configuration
has been
verified, but you
cannot run tasks
on the link. Upon successful
completion of an
integrity check, or
manually from
status Enabled. Manually to status
Enabled, or after
modification of link
configuration to status
Unvalidated.
Enabled The link’s
configuration
has been
validated, and
you can run
tasks on the
link. Manually from
status Disabled. Manually to status
Disabled, or after
modification of link
configuration to status
Unvalidated.