Maintenance, Cleaning and storage – Hunter Fan WARM MIST 35216 User Manual

Page 6

Advertising
background image

6

44059-01 • 05/11/2010

Maintenance

Cleaning and Storage

3

note: ALWAYS unplug the steam unit from the electrical outlet and allow the

unit to cool before cleaning. Never remove the steam unit while it is plugged in,

electrocution or burning could occur. dO nOt attempt to disassemble the steam

unit. neveR allow water to sit in the tank when not in use.

daily Maintenance:

1. Unplug the steam unit and allow it to cool.

2. Remove the steam unit by pressing the release button on the back above the

power cord and pulling it straight off the tank.

3. Let all water drain back into the tank from the steam unit.

4. Turn the tank upside down and drain any water into a sink or tub. Shake the

unit gently to remove any remaining water.

5. Rinse the tank thoroughly with water, empty, and wipe with a dry, clean cloth.

Figure 3.

6. Wipe the steam unit shaft with a dry cloth. Figure 4.

7. If the medicine cup was used, wipe it out with a slightly damp, clean cloth.

Figure 5.

8. Refill the tank as directed under “initial setup and operation” and resume use.

Weekly Maintenance:

1. Unplug the steam unit and allow it to cool.

2. Remove the steam unit by pressing the release button on the back above the

power cord and pulling it straight off the tank.

3. Let all water drain back into the tank from the steam unit.

4. Turn the tank upside down and drain any water into a sink or tub. Shake the

unit gently to remove any remaining water.

5. Create a 50/50 solution of vinegar and water which should be 1/2 gallon

vinegar and 1/2 gallon water. Pour this solution into the tank. Be sure to

only fill the tank to about 1 inch from the top of the tank. With the steam unit

unplugged, place it back into the tank and soak for 30 minutes. After soaking

for 30 minutes, remove the steam unit.

6. Empty the solution from the tank and rinse the tank. Fill the tank with tap

water. Place the steam unit back into the tank for 30 seconds. Remove the

steam unit and empty the water. Repeat the rinsing steps until the vinegar

smell is gone.

7. Dry with a clean cloth. Clean the medicine cup with a slightly damp clean

cloth.

note: The tank has built-in antimicrobial properties to inhibit the growth of

bacteria, mold, and fungi that may affect the water in the tank. Daily and weekly

maintenance is still necessary to prevent the growth of bacteria, mold, and fungi.

Figure 4.

Refill Tank

Off

Power

Figure 5.

Figure 3.

Advertising