Hitachi 60V500E - Manual (Page 21)

21
AV NETWORK SETUP WIZARD
There are six steps in the setup procedure (DVD setup example below).
5. Follow the steps below to setup your AV network (See page 22 for AV Network Codes).
6. Enter “9999” to uninstall the equipment from your AV Network.
7. See Remote Control A/V NET button usage on page 26.
NOTES: 1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre-
coded into the AV Net.
2. In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please
consult your equipment receiver operating guide. Please also try the AV Net Learning Wizard on page 30.
HITACHI AV NET SET UP
Proper Code Entered
from page 22.
Photo MC
Cable Box
DVD
Move
POWER MENU MORE
INFO Device Setting
DVD
Device Code - - - -
(Enter code “9999” to uninstall)
Video Input No Connection
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input No Connection
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Congratulations
Your DVD is now
connected to your AV network.
HITACHI AV NET SETTING LIST
Device Code Video Audio
DVD 0672 INPUT 1 Using TV
VCR ---- Not Setup Not Setup
CBL ---- Not Setup Not Setup
STB ---- Not Setup Not Setup
PVR ---- Not Setup Not Setup
AVR ---- Not Setup Not Setup
Custom ---- Not Setup Not Setup
EXIT
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input Using TV
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move SEL Select Set Input
Photo MC
Cable Box
VCR
DVD POWER MENU MORE
Move INFO Device Setting
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move SEL Select Set Input
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input Using TV
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move SEL Select Set Input
HITACHI AV NET SET UP
SEL Select
Move 0-9 Input
Move 0-9 Input
THUMB
STICK
THUMB
STICK
THUMB
STICK
THUMB
STICK
SELECT
THUMB
STICK
SELECT
THUMB
STICK
(x2)
9 0
Enter the device (equipment) code listed on page 22.
Use THUMBSTICK ̈ to select the input that the device (equipment)
is hooked-up to.
Transmission test for the device to confirm that the proper code was
set, by selecting (POWER, PLAY, etc.) soft keys shown. If the device
responds to the transmission test soft key, then it is properly set up.
Select OK to continue.
FIRST TIME USE
QR57028 8/17/05 2:49 PM Page 21