Husky TREF1736D - Manual (Page 2)

1. To change the door swing, remove (4) screws located on
the inside face of the cabinet (See Fig. 1). Flip the door
180 degrees. Line up hinge holes with the pre-drilled holes
on the opposite side cabinet face. Secure with hinge screws.
RIGHT AND LEFT DOOR SWING Figure 3 3
Figure 3
1. Place machine screws through predrilled hole in door or drawer.
Line up knob or handle with machine screw and tighten with
screw driver.
2. Repeat process for all additional doors and/or drawers.
KNOB / HANDLE INSTALLATION Figure 1 1
Figure 1
Figure 2
Please read instructions before assembly process.
2
1. Place shelf clips into predrilled holes located inside the cabinet
on the right and left side walls. Once shelf clips are installed
rest wood shelf onto clips.
SHELF INSTALLATION Figure 2 2