Troubleshooting – Homelite UT80432 User Manual

Page 20

Advertising
background image

Page 16 — English

PROBLEM

CAUSE

SOLUTION

Engine fails to start

No fuel in tank

Fill tank

Spark plug shorted or fouled

Replace spark plug

Spark plug is broken (cracked porcelain
or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Ignition inoperative

Replace spark plug

Replace lead wire or attach to spark plug

Contact authorized service center

Engine hard to start

Water in gasoline

Drain entire system and refill with fresh fuel

Weak spark at spark plug

Contact authorized service center

Engine lacks power

Dirty air filter

Clean or replace air filter

Detergent fails to mix with spray

Detergent injection hose is not properly
submerged

Insert injection hose into detergent container
or detergent bottle

Spray selector on the 5-in-1 Change
Over Nozzle is set to either the [40º],
[25º], or [0º] setting

Rotate the spray selector on the 5-in-1
Change Over Nozzle to either the short
range detergent [ ] or long range detergent
[ ] setting.

Pump doesn’t produce pressure

Spray selector on the 5-in-1 Change
Over Nozzle is set to either the short
range detergent [ ] or long range
detergent [ ] setting.

Rotate the spray selector on the 5-in-1
Change Over Nozzle to either the [40º], [25º],
or [0º] setting

Inadequate water supply

Provide adequate water flow

Trigger handle or spray wand leaks

Check connections and / or replace trigger
handle or spray wand

Nozzle is clogged

Clean nozzle

Pump is faulty
Air in line

Contact authorized service center
Squeeze trigger on trigger handle to remove
air from line

Machine doesn’t reach high
pressure

Diameter of garden hose is too small

Water supply is restricted

Not enough inlet water
Spray selector on the 5-in-1 Change
Over Nozzle is set to either the short
range detergent [ ] or long range
detergent [ ] setting.

Replace with 3/4 in. garden hose

Check garden hose for kinks, leaks, and
blockages
Open water source full force
Rotate the spray selector on the 5-in-1
Change Over Nozzle to either the [40º], [25º],
or [0º] setting

TROUBLESHOOTING

Advertising