Hampton Direct H35-NG1 - Manual (Page 37)

Hampton ® H35 Direct Vent Freestanding Gas Stove 37
WIRING DIAGRAMS
CAUTION: Label all wires prior
to disconnection when servicing
controls. Wiring errors can
cause improper and dangerous
operation.
If any of the original wires as supplied with the
appliance must be replaced, it must be replaced
with CSA type SEW (200
o C) or its equivalent.
This heater does not require a 120V A.C. sup-
ply for operation. In case of a power failure, the
burner switch and the optional remote control/
thermostat will continue to operate. However,
a 120V A.C. power supply is needed for the
fan/blower operation.
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with a
three pronged (grounding) plug for
your protection against shock hazard
and should be plugged directly into
a properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
INSTALLATION
For NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes