HotBrick Firewall VPN SoHo 401 VPN - Manual (Page 6)

Page 5
Setup is now completed.
Macintosh Setup
To access the Internet via the SoHo 401 VPN:
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up
menu. The DHCP Client ID field can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the
required changes are:
•
Set the Router Address field to the Soho 401 VPN 's IP
Address.
•
Ensure your DNS settings are correct.
Linux Setup using X Windows
Follow this procedure to set your system to act as a DHCP
client, obtaining an IP Address and related data from the
Soho 401 VPN 's DHCP Server.
1. Start your X Windows client.
2. Select Control Panel - Network
3. Select the "Interface" entry for your Network card. Nor-
mally, this will be called "eth0".
4. Click the Edit button, set the "protocol" to "DHCP", and
save this data.
5. To apply your changes
•
Use the "Deactivate" and "Activate" buttons
•
OR, restart your system.