Husqvarna 13 H - Manual (Page 27)

English –
25
MAINTENANCE
1
2
Dismantling the cutting unit
The cutting unit can be released from the machine
for cleaning or checking of the blades and screws.
Dismantle the cutting unit as follows:
1. Dismantle the front hood and right-hand and left-
hand fenders as described on page 18.
2. Raise the cutting unit by pulling the lift lever
backwards to the transport position.
3. Dismantle the drive belt (1).
4. Lower the cutting unit by pressing in the lift
lever’s lock button and moving the lever to
cutting position, and then setting the lowest
cutting height with the cutting height lever.
5. Remove the hair-needle spring (2) from the
chain retainer.
Fitting of the cutting unit takes place in the reverse
order to dismantling.
6. Remove the lock pins (one on each side) on the
rear edge of the unit.
!
WARNING!
When the lock pins are removed the
unit will drop to the ground. Make sure
to keep your hands or fingers away
from under the unit during dismantling.