Harbor Freight Tools 37822 - Manual (Page 9)

Bench Grinder For technical questions, please call 1-800-444-3353. Page 9
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the tool off and unplug it
before assembling or making
any adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
1. Installing Tool Rests -
a. Turn the Grinder off and unplug it.
b.
FIGURE 1
Install adjustable rests (22 and 35)
to the wheel guards (7 and 27) as
shown in Figure 1. Use bolts and
washers to secure them in place as
shown in Figure 1.
Note: There is a left and a right tool rest.
Refer to Figure 1 to be certain that
you install them correctly.
c. The tool rests should be adjusted to
within 1/16” of the grinding wheel.
To adjust this distance, move Adjust-
able Rests (22 and 35) by loosening
bolts and moving them to the proper
position.
2. Installing Spark Guards -
a.
FIGURE 2
Select spark guards (17 and 18),
washer and bolt. Install the right
spark guard to the wheel guard as
shown in Figure 2.
b. Adjust the spark guard to within
1/16” of the grinding wheel. Repeat
for left side.
Note: There is a left and right spark guard.
Refer to Figure 2 to be certain that
you install them correctly.
REV 01b