Hama VPL-CX86 User Manual
Page 29
C:\data\Projector\AirShot\AirShot_FMData\2634400112_VPL-
CX8676_AirShot\2634400112_VPL-
CX8676_AirShot\2634400112\2634400112VPLCX8676WW\02C01.fm
masterpage: Right
29
Others
VPL-CX86/CX76
2-634-400-11 (1)
Projector connection
established already.
a
• The computer cannot communicate with the projector as
the other computer has already established
communications with the projector.
c After the projector is disconnected from the computer,
communicate with the projector again.
Selected PC exceeds
maximum number of
connection.
a
• You tried to connect more than 5 projectors to one
computer.
c Reduce the number of the connected projectors to 4 or
less and then connect it again. (The maximum of 5
projectors can be connected to one projector.)
Projector is stand-by.
a
• The projector you are trying to communicate is in the
standby mode.
c Turn on the projector and then try communicating it.
No response from
projector.
a
• The Air Shot Version 2 communications are blocked
because of the Firewall.
c Change the Firewall settings so that the Air Shot
Version 2 communications are not blocked.
• Wireless transmission conditions are extremely bad.
c Place the projector close to the computer, or remove the
obstacles between the projector and computer.
• The power cord of the projector is removed.
• The wireless card is removed from the projector.
c Check the projector status.
• While connecting to the projector by using the USB
wireless LAN module, the USB wireless LAN module
is removed.
c Restart Windows and start the Air Shot Version 2, and
then connect the USB wireless LAN module.
Unable to switch
resolution of PC desktop.
a
• When the screen resolution of the computer is not
identical with the projector LCD panel resolution, and
when the computer is connected to the projector with
[Set PC desktop to Projector resolution] of the [Option
Setting]-[Connection Setting] checked, the resolution
switching of the computer cannot be done successfully.
c If the message appears every time the computer is
connected to the projector, uncheck [Set PC desktop to
Projector resolution].
LAN Module with same
network address exists.
a
• The IP address on the same subnet mask which is used
by the Air Shot Version 2 LAN module has been
assigned to another LAN module.
c Check the IP Address Setting of the LAN module used
with the Air Shot Version 2 and that used in the
computer. Then change the settings so that their
network addresses are not identical.
USB Wireless LAN
Module disconnected
while connecting.
a
• While the computer is connected to the projector, the
USB wireless LAN module is removed.
c If the USB wireless LAN module is removed during
connection, the computer may become unable to
establish proper connection with the projector. To
remove the USB wireless LAN module, make sure to
disconnect the device.
Message
PC PJ
Cause and Remedy