haier HDW201WH - Manual (Page 6)

Starting a Wash Cycle
After completing the installation, turn on the water and press the
ON / OFF button (A) located on the control panel. The indicator
light "B" will come on indicating that the appliance is on, but you
must wait a few seconds before programming the cycle.
Selecting a Wash Cycle
Select the desired cycle by pressing the selector button (G). Each
time the button is pressed, one of the cycle indicator lights "H"
will come on. Choose the wash cycle you feel is most
appropriate for the type of dishes that need washing from the
wash cycle chart on page seven.
Press the Start / Pause button (I), and after a few seconds a
short beep will indicate that the wash cycle has begun and can
no longer be changed. If necessary, read the next paragraph,
"Cancelling or altering a cycle while underway..."
Cancelling or altering a cycle while underway
A cycle that is underway cannot be altered.
It must be stopped by pushing the
ON-OFF button (A) to
cancel all the settings and then restarted as described in the
preceding instructions. If the cycle is stopped after it has been
running for some time, the detergent may have already been
used, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be
refilled (see the paragraph entitled, "Loading the Detergent").
If you forget to load some of the dishes
To load additional dishes, push the Start/Pause button to
interrupt the cycle, load the dishes then turn the appliance back
on using the Start / Pause button. The cycle will continue from
where it left off.
Wash Cycle Programme Light
The wash cycle is running when the cycle indicator light (H) is
blinking.
At the end of the Wash Cycle
Six beeps will indicate that the wash cycle has finished and the
cycle indicator light (H) will turn off. Turn the appliance off using the
ON-OFF button. Turn off the water supply to the appliance and
open the door. Wait a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry
better.
Setting the Wash Cycle with a Delayed Start Time
After selecting the wash cycle as indicated in the paragraph
entitled, "Setting and Starting a Wash Cycle..." the delay time can
be set.
By pressing the button "E" (see close-up view-'Control panel") the start
of the wash cycle can be delayed for between 1 to 9 hours. Each time
the button is pressed, the display (F) will show the number of hours
for the delay period. Select the desired delay and push the Start /
Pause button "I". The machine will beep and the delay time on the
display will blink, indicating that the countdown has begun. After the
time has lapsed, the cycle will start.
NOTE:
a) During the delay period, do not change any of the settings.
If it is necessary, all of the settings must be cancelled by pressing
the ON-OFF button (A) and the machine re-programmed following
the instructions contained in the preceding sections.
b) If the door is opened during the delay period, the indicator will
blink and beep, and the countdown will stop. It will continue when
the door is closed.
Wash Cycle Adjustment Buttons
1/2 Load Button
This button
"C"
makes it possible to wash dishes using only the
upper rack when there are not enough dishes for a full load. This
will save water and power. It can be used before setting any of the
wash cycles, except for the intensive cycle. Please keep in mind
that the amount of detergent should also be cut in half.
.5.
Operating the Appliance