Switching source signals, Adjusting the volume, Switching source signals adjusting the volume – HANNspree DT06-10A1 User Manual
Page 28: Switching source signals press the, Button on the remote control or the, Adjusting the volume press the, On the remote con- trol or press the
27
Switching Source Signals
Press the
SOURCE
button on the
remote control or the
TV
button
on the control panel to select the
incoming source signal.
The current source setting CH xx
appears on the top left corner of
the screen; AV1 or AV2 appears
on the bottom right corner of the
screen.
Note
The TV supports S-Video input in
addition to normal video and audio signals. The TV detects the signal type
automatically and gives priority to S-video when two signals are detected
at the same time. This auto detection function is only available for AV2.
Adjusting the Volume
Press the
VOL UP button
to
increase the volume. Press the
VOL DOWN button
to decrease the
volume. The volume level is dis-
played on the TV.
Press
MUTE
on the remote con-
trol to turn the sound off. The
word “Mute” appears on the top
left corner of the screen and
sound is temporarily turned off.
Press
MUTE
on the remote con-
trol or press the
VOL UP button or
the VOL DOWN button
to restore the original volume.
TV
M
CH
CH
TV
Current source setting
TV
Volume
TV
M
CH
CH
DOWN Volume UP
Mute