HONDA HHT31S - Manual (Page 15)

CONTROLS & EQUIPMENT
13
EQUIPMENT
The Honda HHT25S and HHT31S trimmer/brush
cutters are supplied with a shoulder harness and
safety glasses. Refer to page 14 for a description
of other equipment and protective clothing you
will need.
Shoulder Harness
A full shoulder harness must be worn by the
operator of these Honda trimmers/brush cutters
when equipped with a blade and debris shield. If
the trimmer is equipped with a cutting-line head
and shield with cutoff knife, the operator may
wear a single-strap harness
A suitable shoulder harness is supplied with each
new Honda HHT25S and HHT31S trimmer/brush
cutter. Replacement shoulder harnesses may be
purchased through any authorized Honda
trimmer/brush cutter servicing dealer.
Before operation, adjust your shoulder harness
as described on page 16.
Quick-Release Latch
The shoulder harnesses supplied with these
trimmers are equipped with a quick-release latch.
Pull the latch tab upward to detach the trimmer
from the harness.
Insert the latch tongue in the slot of the quick-
release latch to reattach the trimmer to the
harness.
Safety Glasses
Safety glasses or goggles that comply with ANSI
(American National Standards Institute) standard
Z87.1 must be worn by the operator of any
Honda trimmer/brush cutter. The safety glasses
supplied with each new Honda HHT25S and
HHT31S trimmer/brush cutter complies with this
ANSI standard.
FULL SHOULDER HARNESS (UNBA only)
QUICK-RELEASE LATCH
QUICK-RELEASE LATCH
SINGLE-STRAP SHOULDER HARNESS (LTA only)
QUICK-RELEASE LATCH
LATCH TAB
SAFETY GLASSES (ANSI Z87.1)