HONDA HHT31S - Manual (Page 46)

44
ASSEMBLY
TRIMMER ASSEMBLY (UNBA types only)
U-Shaped Handlebar Installation
1. Remove the four 5 x 28 mm bolt/washers and
handlebar holder A.
2. Set the U-shaped handle into handlebar
holder B with the throttle trigger facing to the
right.
3. Adjust the handlebar position as shown.
4. Tighten the four 5 x 28 mm bolt/washers.
TORQUE: 3.6 ft lb (5 N·m, 0.5 kg-m)
5. Make sure the tie straps are positioned as
shown.
6. Operate the throttle trigger and make sure the
throttle operates smoothly.
5 x 28 mm BOLT/
WASHER(4)
HANDLEBAR
HOLDER A
THROTTLE TRIGGER
U-SHAPED
HANDLEBAR
HANDLEBAR
HOLDER B
90°
3.9 in (100 mm) 2.4 in (60 mm)