Homelite HL80833 - Manual (Page 11)

7 — English
PROdUcT SPEciFicATiONS
Engine ................................................................................................................................................................... 170cc OHV
Fuel Tank Capacity .....................................................................................................................................................0.29 gal
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,600 psi
Maximum Gallons Per Minute* .................................................................................................................................. 2.4 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101, when tested with red nozzle
KNOw yOUR PRESSURE wAShER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
SURFAcE cLEANER
The surface cleaner can be used to clean large flat areas using
less time and energy than when using the spray wand.
ENgiNE SwiTch
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.29 gal. Use
unleaded automotive gasoline in the engine.
high PRESSURE hOSE STORAgE
Once the high pressure hose is rolled, hang it on the back
of the machine using the hook-and-loop strap to secure in
place.
170cc Ohv ENgiNE
This engine enables the pressure washer to achieve
2,600 psi (pounds per square inch) at a rate of 2.4 gpm
(gallons per minute).
NOZZLE hOLdER wiTh SPRiNg cLiP
The spring clip attached to the nozzle holder allows you to
clip the nozzle holder to the unit or wear it on your belt for
convenience.
STARTER gRiP wiTh ROPE
The starter grip with rope is pulled to start the machine.
SOAP BLASTER ™ NOZZLE
The Soap Blaster™ nozzle can be easily adjusted for long
range or short range cleaning.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
ThERMAL RELiEF vALvE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
TRiggER hANdLE
The trigger handle has a gripping surface that provides added
cont rol of the spray wand and helps reduce fatigue.
TRiggER wiTh LOcK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.
FEATURES