Hoover S1211 - Manual (Page 20)

How to replace the brushes
(Brushes HOOVER part No. 48445001)
Disconnect cleaner from electrical outlet.
1. To replace worn brushes, remove bottom plate, belt and agitator,
following directions given on preceding pages.
2. Turn end plates of agitator in
opposite directions until one end
plate comes off.
END PLATES
3. Then pry out end section as
shown.
4. Remove opposite end plate
and shaft by pulling straight out.
Pry out remaining end section.
5. Remove brushes by pulling them
from agitator. Use pliers if neces-
sary. Slide new brushes into chan-
nels. Push them in as far as possi-
ble.
19