Refueling, Restriction plates, De-ashing – Heartland The Artisan User Manual

Page 14: Cleaning of bottom grate, Use of the hot plate

Advertising
background image



Refueling

The firebox should be filled to the recommended level at

the middle of the firebox door opening.

A correctly fueled fire will last a minimum of 2 hours

burning wood when maintaining the maximum rated

output of the stove with intermittent cooking periods

included.

Once refueling has been completed, close the

firebox door immediately and open only for refueling

charges.

Restriction Plates

Your unit comes supplied with three rectangular air

restriction plates on the bottomgrate. These should

always be in place during operation to control the

amount of air into the firebox. They should be removed

to clean the bottomgrate and to use the riddling rod on

the left hand side of the unit but must be replaced after

cleaning.

De-Ashing

NOTE: Should the bottomgrate de-ashing fail to

clear an accumulation of ash and debris, it may be

removed as described in the section on removal of

melted ash.

Open the ashpit door to give access to the ashpan which

must be emptied regularly (See Fig. 9).

In winter, this may be as much as three times daily

depending on weather severity.

NOTE: Do not allow ash to accumulate in the ash

pan until it touches the underside of the bottom

grate bars or they will quickly burn out.

Ensure the ashpan is in place otherwise the ashpit

door may not close and lock completely.

Cleaning of Bottom Grate

Due to an accumulation of ash and other material, it may

not be possible to pass through the grate. Allow the fire

to burn out and then open the ashpit door. Lift off the

cleaning door (See Fig. 10) and insert a hooked poker to

draw out any offending accumulation. Replace cleaning

door after use.

The amount of accumlated debris is dependent on the

heating load and should be checked weekly for any

build-up. Excessive build-up will lead to a fall in heating

output and reduction in life of the bottomgrate.

Use of the hot Plate

The best results can be obtained by using machined

base cookware. The hottest part of the hot plate is

immediately above the fire, the other end being for

simmering.

The circular plug in the hotplate (near the flue chamber

end) is for flue cleaning and must not be removed for

cooking.

Keep the hotplate clean with a wire brush.

Continuous use of the oven with the hotplate covers

down may result in discolouration of the hotplate and the

chrome covers.

NOTE: To obtain optimum hotplate performance for fast

boiling or hotplate cooking, fuel the firebox to the bottom

edge of the firebox opening to a horizontal level.

WARNING: The stove top plate surface around the

hotplate will become hot under use and care must be

observed. Please refer to the installation instructions on

page 7 regarding minimum clearances to combustible

surfaces and materials.

-

Advertising