Heath Zenith 598-1283-00 - Manual (Page 3)

3 598-1283-00
Fixture
Screw
Fixture
Screw
Ground
Screw
WIRING
Black to black
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and twist one end together with the bare fixture
wire and the box ground wire. Secure with a wire connector. Secure the other end of the
"pigtail" with the GND screw on the mounting plate.
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green “pigtail”. If you are unsure about
the grounding method, consult your local
building code.
Wire
Path
Junction
Box
Screws
Horizontal Junction Boxes Only:
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screws holes. Wire path must be located
as shown above.
White to white
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Note: All wiring should be run in accordance
with the National Electrical Code through
conduit or another acceptable means.
Contact a qualified electrician if there is
any question as to the suitability of the
system.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and
secure with wire connectors.
One Motion Light
Two Motion Lights
Black
White
Green
or Bare
Light
Fixture
Black
White
Green
or Bare
Light
Fixture
Light
Fixture