Heath Zenith 598-1283-00 - Manual (Page 7)

7 598-1283-00
SYMPTOM
Light stays
on continu-
ously.
Light flashes
on and off.
POSSIBLE CAUSE
1. The sensor is pointed at
nearby objects that cause
heat to trigger the sensor.
(Aim the sensor away from
nearby objects.)
2. The sensor is pointed
toward a heat source like
an air vent, dryer vent,
or brightly-painted heat-
reflective surface. (Re-aim
sensor.)
3. Light control is in Manual
Mode. (Switch to Auto.)
. Light control is in D
ual
B
rite
®
mode.
1. Heat being reflected from
other objects may be
affecting the sensor. (Re-
aim sensor.)
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit
breaker is turned off.
. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if
this is a new installation.
6. Re-aim the sensor to cover
desired area.
1. Light Control may be in-
stalled in a relatively dark
location.
2. Light Control is in Test. (Set
control switch to an ON-
TIME position.)
1. Light Control may be sensing
small animals or automobile
traffic (re-aim sensor).
2. Sensitivity is set too high.
(Reduce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes
on in day-
light.
Light comes
on for no
apparent
reason.
TROUBLESHOOTING GUIDE
TECHNICAL SERvICE
Please call 1-800-858-8501 (English speaking only) for assistance before returning
product to store.
If you experience a problem, follow this guide. You may also want to visit our Web site at:
www.desatech.com. If the problem persists, call* for assistance at 1-800-858-8501 (English
speaking only)
, 7:30 AM to :30 PM CST (M-F). You may also write* to:
DESA Specialty Products
P.O. Box 9000, Bowling Green, KY 2102-900
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available: Model
Number, Date of Purchase, and Place of Purchase.
No Service Parts Available for this Product