Hotpoint TCD975 - Manual (Page 3)

3
Important Information
Condenser Unit...
! You MUST clean the fluff from the condenser EVERY
month.
! Failure to clean the condenser could cause premature
failure of your dryer.
● Check that:
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their ‘lock’ position.
STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits.
STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
Rotate 3 clips
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal).
GB
Impor
tant
Inf
ormation
Installation
Description
The Displa
y
Star
t and
Pr
ogrammes
Laundr
y
W
arnings and
Sug
g
estions
T
ro
u
b
leshooting
S
e
rvice
Maintenance
and Care