Hoshizaki KMS-1400MLH - Manual (Page 15)

1
CAUTION
If a gap is left between the bin control and the wall of the dispenser, ice may
get between them and damage the bin control. Therefore, make sure there is
no gap.
12) Make sure the bin control is flush with the dispenser unit/storage bin wall, then tighten
the 2 thumbscrews.
13) Pull the bin control lead so that there is no slack in the ice drop area, then secure the
hose that the lead runs through with a cable tie.
10) Slightly loosen the outer 2 thumbscrews.
11) Slide the thumbscrews into the slots on the bin control bracket. The bin control bracket
is located on the back wall of the icemaker.
1
Evaporator
Bin Control Lead
Cable Tie
To Control
Box
Plastic Pipe
Hose
10
Thumbscrews
11
Slots
14) Replace the tank in the icemaker and reconnect the 4 hoses.
15) Replace the front frame and insulation in their correct positions and secure with the
thumbscrews.
16) Replace the panels in their correct positions.